![]() |
MPA5500 A.C. POWER ADAPTOR The MPA5500 enables any MTL5500 Series module that is normally powered from a nominal 24V DC supply (i.e. those that are not loop-powered) to be powered from a high-voltage AC supply. It plugs into the power socket (terminals 13 and 14) of an MTL5500 module and clips ... Read More
|
![]() |
Last month we successfully delivered the MTL5546Y to our client in Israel, and today we also successfully delivered MTL5544D ordered by our client in Oman(this is our second new Oman client) by the end of December. Here we sincerely express thanks to the two new clients for their support. At present... Read More
|
![]() |
For acceptance of the MTL Safety Barriers which were ordered two months ago, one of our clients from Oman visited our office last month. During his visit to our office, he was fully satisfied with the result of the acceptance, this means the beginning of the further cooperation, then we had a ... Read More
|
![]() |
The MTL7742 is a single channel switch/prox input barrier with an open collector solid state interface to the safe area equipment. The solid state switch is especially useful for high frequency switching apparatus including pulse and rotational sensors. The power bus terminal can be used to connect ... Read More
|
![]() |
HOW THEY WORK All MTL7700 Series barriers are based on the same simple principle. Each channel contains two stages of pulse-tested Zener or forwardconnected diodes and an ‘infallible’ terminating resistor. In the event of an electrical fault in the safe area, the diodes limit the voltage that can ... Read More
|
![]() |
The MTL7741 is a single channel switch/prox input barrier with changeover relay contacts acting as the safe area interface. Relay contacts provide a universal interface capable of switching a wide range of signals including ac, low level and high level voltages. Phase reversal is achieved by ... Read More
|
![]() |
The MTL7798 power feed module incorporates both voltage and current sense mechanisms to protect barrier circuits by activating a solid state trip mechanism when fault or overload conditions occur in the power source circuit. Resetting the module after tripping is achieved by interupting the supply ... Read More
|
![]() |
The MTL7745 is a single channel switch/prox input barrier providing line fault detection. Proximity detectors or switches fitted with end-ofline resistors may be connected. Short circuit or open ciruit conditions in the field wiring will generate an alarm condition. The LFD relay contacts close when ... Read More
|